From grout surface treatment to full wall cavity remediation — the right scope for your specific bathroom mold situation in Henderson, KY.
🔍
Bathroom Mold Investigation & Source Identification
Systematic investigation: moisture readings at shower walls, floor at pan perimeter, toilet base, under sink. Borescope through wall cavities. Exhaust fan flow measurement. Written findings before any demolition.
🚿
Shower & Tub Surround Mold Remediation
Mold in shower and tub surrounds is most commonly found in one of three locations: surface grout and caulk (visible, usually Aspergillus or Cladosporium); behind tile on the CBU or drywall backer (typically from grout failure allowing water infiltration); or in the wall cavity behind the shower from a failed pan liner or cracked pan. Each requires a different approach — our Henderson specialists assess which applies before proposing removal scope.
💧
Subfloor Mold Removal — Toilet Leaks & Shower Pan Failure
Subfloor mold from toilet leaks and shower pan failure is often more extensive than it appears. We remove contaminated sections, treat remaining structural wood, and specify moisture-appropriate replacement material. Toilet wax ring or shower pan repair is coordinated before reinstalling flooring.
🔢
Exhaust Fan Assessment & Upgrade Recommendation
Inadequate bathroom exhaust fan CFM is a primary cause of chronic bathroom mold on drywall and ceiling surfaces in Henderson, KY homes. We measure existing fan output, compare against HVI recommended CFM for your bathroom square footage, and specify an appropriate replacement if the existing fan is undersized — a simple correction that dramatically changes long-term mold risk.
🌟
Ceiling Mold — Condensation & Leak Sources
Bathroom ceiling mold occurs in two distinct scenarios: condensation from chronic inadequate ventilation (which leaves a diffuse, widespread pattern on the ceiling surface), and drip from a bathroom above (which creates a concentrated pattern tracing the path of the drip). Our Henderson, KY team distinguishes between these, addresses the correct source, and remediates accordingly — surface treatment for condensation mold, cavity investigation and source repair for drip sources.
📄
Post-Remediation Clearance & Documentation
Independent post-removal air sampling before any reinstallation begins. Written clearance report confirms the mold is gone before new materials go in.
